17
4. Camera Setups
4.1 How to copy settings set by the MCU-200S from one camera to
another
When the MCU-200S is used to control more than one camera, it is possible to copy the settings
set by the unit on one camera to another via the Memory Stores functions of the unit.
Follow the following procedure to copy the settings set by the unit on camera to another.
1. Select the camera from which you want to copy the settings via the CAM 1 to CAM 4
buttons.
2. Press the LOAD SAVE button to start the copy process. The LOAD SAVE button will be back
lit orange and blinking.
3. Whilst the LOAD SAVE button is back lit orange and blinking select the camera to which you
want to copy the settings via the CAM 1 to CAM 4 buttons.
4. When the LOAD SAVE button is back lit green the copy process is then completed.
Note: This process does not work if either the selected source or destination camera is not
connected or is not powered on.
4.2 How to store / recall settings from internal memory (MU-1 / MU-2 /
MU-3)
The MCU-200S has dedicated internal memory to store the settings set by the unit on four cameras.
This internal memory can be accessed using the Memory Store functions.
Internally, the unit has three memory blocks indicated by the Memory Stores MU-1, MU-2 and
MU-3. Each of these blocks is divided into four segments, one segment for each camera. These are
used to store the settings for each camera accordingly.
Use this procedure to store the settings on a camera to the MCU-200S unit’s internal memory.
1. Select the camera from which you want to copy the settings via the CAM 1 to CAM 4
buttons.
2. Press the LOAD SAVE button to start the copy process. The LOAD SAVE and the selected
camera button will be back lit orange and blinking.
3. Whilst these buttons are back lit orange and blinking select the memory block, MU-1, MU-
2 or MU-3 button, to which you want to copy the settings.
4. When the MU-1, MU-2 or MU-3 button is back lit green and the copy process is then
completed.
Use this procedure to recall a previously saved setting on the MU-1, MU-2 or MU-3 button to a
camera.
1. Select the camera to which you want to copy the stored settings via the CAM 1 to CAM 4
buttons.
2. Select the memory block from which you want to copy the settings via the MU-1, MU-2 or
MU-3 button.
To Next Page
Loading...
Need help?
General
