Software (Drivers & SDK ):
Because of the continually evolving Driver & SDK to support new mobile devices,
Drivers & SDK are distributed online and is available for download at our website
indicated below. For details on using the DPP-450 Drivers & SDK, please refer to the
SDK’s documentation.
http://www.datecs.bg/en/products/DPP-450/2/264#
5. Getting started
The DPP-450 allows you to printer information from your PDA & Smart
phone. Before using the DPP-450 thermal printer the battery should be properly
charged. The following Quick Start guide will help to get your DPP-250 ready
for use.
Steps What to do Purpose
Where to find more
information
1
Charge the DPP-450
rechargeable battery
pack as
recommended in this
manual
The Lithium Ion battery
pack should be fully
charged before use to
ensure long battery life.
Charging Battery,
Page 9
2.1
Load DPP-450 print
media(Thermal paper
roll)
DPP-450 requires Thermal
paper for printing.
Loading Paper, Page
10
2.2
Load DPP-450 print
media(Thermal label
paper)
DPP-450 requires Thermal
label paper.
Loading Paper, Page
10
3
Setup Bluetooth
Paring
Setup Bluetooth pairing to
allow DDP-450 to
communicate with
Bluetooth devices.
Bluetooth Setup,
Page 24
4
Install DPP-450
Software
To print information from
your device, software
needs to be installed onto
your device.
Install DPP-450
Software, Page 8
To Next Page
Loading...
