What to do if the module indicated is no longer communicating in my Davey Water Filtration System?
If the module indicated is no longer communicating with the Davey Water Filtration System, ensure all modules are properly connected to the system and to each other. Modules can be tested individually by plugging them in one at a time and cycling power to the system. Replace any module that is not detected when plugged directly into the controller.
Why is my Davey Water Filtration System lamp on but not disinfecting?
If your Davey Water Filtration System's lamp is on but not disinfecting properly, it might be because the lamp's UV output is no longer sufficient due to its age. Replace the lamp with the correct part, which is indicated on the silver label on the reactor or on the Maintenance parts screen.
What to do if a bad connection has been detected in the IEP port of my Davey microlene MCS?
If a bad connection is detected in the IEP port of your Davey Water Filtration System, first ensure that the lamp key (packed with the lamp, on the connector) is installed. Unplug and reinstall the key. Also, verify that the key part number matches the Lamp listed on the Maintenance Parts screen.
Guidance on carefully installing the quartz sleeve without touching it with bare hands.
Instructions for tightening the gland nut and inserting the spring for lamp alignment.
Steps for plugging the lamp connector into the lamp and gland nut.
Lists hard alarms, their causes (e.g., lamp failure, low UV), and corresponding resolutions.
Lists conditions and factors that void the warranty, such as water quality and installation.
General| Brand | Davey |
|---|---|
| Model | microlene MCS |
| Category | Water Filtration Systems |
| Language | English |
To Next Page
