1615
Settlement
Insert the plug tightly.
Check the socket or change to another socket.
Press power switch.
Check power supply.
Install the inlet hose again.
Tighten the connector of the machine.
Restart when water supply is resumed.
Open the tap.
Clean the lter according to before “clean inlet gate”.
The machine is adjusting automatically.
Close the top lid.
Normal
Normal
Notes: If there is still a fault after the above checks, please pull out the plug and
contact the seller right away. It is dangerous to repair this product by yourself.
Put down the drainpipe.
Straighten or clean the drainpipe.
Settlement
Other functions
1. Give an alarm
4. Child lock function
(1) If set child lock function, all the buttons will be locked including POWER. If the top lid
is opened during the washing machine working, the washing will be stopped and give an
alarm. But if you can close the top lid in 5 seconds, the washing machine will stop alarm
and continue working. If cannot close the top lid in 5 seconds, the washing machine will
begin draining if there is water in the inner tub, even closing the top lid is not valid. During
the draining, alarm will be given every 10 seconds , when the water in the inner tub is about
5cm higher, alarm will be given every 10 minutes (alar m is always given). When the draining
is nished, the was
hing machine will be in the state of waiting, if close the top lid, the washing
machine is unlocked and start working as previous setting.
(2) Once child lock is set, if open top lid over 5 seconds during washing or rinse (there is water in
the inner tub), washing machine will drain and give an alarm. If you unlock the function during
draining, the washing machine will add water to setting water level and continue working.
E1
E3
E2
F1
E4
E0
Display
Explanation
Settlement
The top lid is opened
when preset is started.
Close the top lid and clear up the alarm.
After draining 5 minutes,
it still does not reach to
water level.
Open top lid, according to before
troubleshooting and settlement to
settle it, then close the top lid and
clear up the alarm.
The top lid is open when
spinning.
Close the top lid and clear up the
alarm.
Spin does not balance.
Open the top lid, make the laundries
place equally, then close it and clear
up the alarm.
After inlet 40 minutes still
not reach to setting water
level.
Open top lid, according to before
troubleshooting and settlement to settle
it. Then close the top lid and clear up the
alarm.
Water level sensor is
wrong.
Cut the power supply and call the
technicians.
vibration testing system will supervise the running. Once vibration is beyond certain
3. Power supply is cut off automatically
violent vibration. This machine has imbalance adjustment function, and the
During spinning, if the laundries are not placed equally in the tub, it would cause
2. Imbalance adjustment
level, the adjustment system will start automatically to adjust the imbalance.
5. Water recycle function
If set water recycle function, after the last time rinse nished, the washing machine will not
drain and spin, SPIN and WATE R RE CYCLE indicator light are ashing and an alarm is given,
the washing machine stop working (if nobody operate, the alarm will be given every 10 minutes,
in 1 hour, power supply will be cut off automatically) . When press START/PAUSE , WATE R RE CYCLE
indicator light is on and the washing machine begin to drain and spin, the user can reuse the wa
ter.
E5
Child-lock light ashing
synchronously.
The top lid is opened
after setting child-lock.
1) Press the power supply button and does not start the program in 10 minutes,
the power supply will be cut off automatically.
2) After the washing is nished, buzzer will remind, the power supply
can be cut off automatically.
Close the top lid and clear up the
alarm.
To Next Page
Loading...
Need help?
General
