Maintenance
Operation
1.Once you have using the machine, you are advised to turn off the water taps. (If necessary, pull out
the inlet hose).
2. Do not keep water in tub for a long time. When washing is nished, drain it right away.
3. Once you have nished using the machine, you are advised to unplug it.
4. Put the electric cable and the drain hose in order.
5. Wipe the water on the surface and in tub with soft cloth and keep the top lid opening for a while. It
helps to prevent mould and stagnant smells forming inside the appliance.
The machine stops automatically, and buzzer
will remind you to take out the laundries
or start again.
Once you have nished using the machine,
you are advised to unplug it and turn off the
water taps to avoid unexpected leak or re.
After the end of the programme
Clean the exterior cabinet of the appliance with
soft cloth. Do not use cleanser, volatile chemical
materials to clean the machine, which will
damage plastic parts and the surface.
External cleaning
Clean inlet gate
It is possible that the inlet lter net can be blocked
by the dust,
please clean it according to the
following steps:
1. Close the tap and turn on the power switch.
2. Start the washing machine for 5 seconds (make
the water in the inlet hose ows to the tub), and
cut off the power supply.
3. Pull off the inlet hose, remove and clean the
inlet valve and the inlet net, and install again.
Maintenance methods
If the water in the inner tub has possibility to freeze, please do like below:
1. In winter, if remaining water freeze can cause the washing machine trouble,
please take off the water inlet hose and drain out the water in the hose and inner tub
2. If the water freeze, please don't operate the washing machine. Put 40
o
C hot water.
in the tub, the hot water should submerge the pulsator, after a few minutes, rotate
the pulsator by hand gently, then you can operate the washing machine.
Magic lter cleaning
1. Pull out magic lter.
2. Open the box and clean it.
3. Close it and reinstall it.
4. Check if the lint block part is in good condition
press this part and pull out to take
out the magic lter.
lint block part (black rubber)
1413
Troubleshooting
It does not drain
It does not inlet
Spin stops and begins to inlet
during spin program
Press the program button to
select SPIN, but it does not spin
The spin is intermittent when spin
starts
First time to use, some water ows
from the drainpipe
No water supply.
Tap is not open.
Inlet hose gets blocked.
Laundries is too much or too little or the
machine is not place stably.
Before contacting the technicians, please make the following checks:
Control panel has no any display
Plug is not inserted tightly.
No electricity in the socket.
Power switch is not turned on.
Power supply is cut off.
Inlet hose leaks
Inlet hose connector (connecting with the tap) is not xed tightly.
Inlet hose and washing machine connector is loose.
Drainpipe is not put down.
Drainpipe is bended or get blocked.
The remaining water when the factory make test.
Do not close the top lid when drain is nished.
Open up the top lid when start drain.
Balance the laundries to reach to the best spin effect.
Phenomena
Possible reason
To Next Page
Loading...
Need help?
General
