Enclosure Components:
B) Baffle
C) 2 x Side Panel
D) Back Panel
E) 2 x Top/Bottom Panel
F) Brace
Enclosure Assembly:
1) First, before gluing anything, do a dry fit of the enclosure to familiarize yourself
with the parts and assembly. This will also give you a chance to ensure that all pieces have
been cut properly.
2) Next, set the enclosure parts out on a flat level surface and ensure that all pieces are
free of dust and debris.
3) Start with the Back Panel (B) lying flat with the rabbeted side up, as shown.
To Next Page
