4) Apply a small bead of glue to the inside of all joining surfaces of the Back Panel (B) and
one Top/Bottom panel (E). Then set in place applying enough pressure to ensure glue is spread
through each joint (some glue squeeze-out can be expected).
5) Apply a small bead of glue to the inside of all joining surfaces of one Side Panel (F)
and
the back and top/bottom panel assembly. Then set in place applying enough pressure to ensure
glue is spread through each joint (some glue squeeze-out can be expected).
6) Apply a small bead of glue to the inside of all joining surfaces of the Brace (E)
and the
back, top/bottom, and side panel assembly. Then slide in place applying enough pressure to
ensure glue is spread through each joint (some glue squeeze-out can be expected).
To Next Page
Loading...
