7) Apply a small bead of glue to the inside of all joining surfaces of the other Side Panel (F)
and the enclosure assembly. Then set in place applying enough pressure to ensure glue is spread
through each joint (some glue squeeze-out can be expected).
8) Apply a small bead of glue to the inside of all joining surfaces of the other Top/Bottom
Panel (E)
and the enclosure assembly. Then set in place applying enough pressure to ensure glue
is spread through each joint (some glue squeeze-out can be expected).
9) Apply a small bead of glue to the inside of all joining surfaces of the Baffle (E)
and the
enclosure assembly. Then set in place applying enough pressure to ensure glue is spread through
each joint (some glue squeeze-out can be expected).
To Next Page
Loading...
