14
DriveRack™
dbx
This LED (when lit) indicates that the 481 is sending/receiving from a personal computer through
the GUI interface.
Input Meters
The 481 DriveRack™ provides the user with four independent 12 seg-
ment lightpipe™ input meters that range from -30 to +22 dBu.
Output Meters
The 481 DriveRack™ provides the user with eight independent 12-seg-
ment lightpipe™ output meters that range from -30 to +22 dBu.
Power Switch
Turns the 481 DriveRack™ on and off.
IEC Power Cord Receptacle
The 482 comes with an International power supply that will accept voltages ranging from 100V-
240V at frequencies from 50Hz-60Hz. An IEC cord is included.
MIDI In and Out/Thru Connectors
These connectors provide full MIDI functionality to the 482 DriveRack™. The In, Out and Thru
jacks allow you to use the 482 DriveRack™ at any point in the MIDI chain.
RS485 Control Bus Input (DB-9 connector type)
This input network connection is used to receive information being sent from other units in the
DriveRack™ network link.
RS485 Control Thru Bus (DB-9 connector type)
This Thru network connection is used to pass information to other units in the DriveRack™ net-
work link.
RS485 Control Bus Input (RJ-45 connector type)
This input network connection is used to receive information being sent from other units in the
DriveRack™ network link.
RS485 Control Thru Bus (RJ-45 connector type)
Rear Panel Connections (482)
To Next Page
Loading...
