Need help?Do you have a question about the dbx DriveRack PA+ and is the answer not in the manual?
General| Type | Loudspeaker Management System |
|---|---|
| Input Channels | 2 |
| Output Channels | 6 |
| Crossover | Yes |
| Delay | Yes |
| Dynamic Range | >110 dB |
| A/D Resolution | 24-bit |
| D/A Resolution | 24-bit |
| Sample Rate | 48kHz |
| EQ | Parametric, Graphic |
| Compressor | dbx Compressor |
| Frequency Response | 20Hz - 20kHz |
| Power Supply | 50/60Hz |
| Dimensions | 19" x 1.75" |
Illustrates the connection of a typical stereo 2-way sound system.
Wire the console, DriveRack, amplifiers, and speakers as shown in the diagram.
Start the wizard, set system input to Stereo, and configure Graphic EQ.
Choose main and sub speaker models, and select the High amplifier model.
Select Low amplifier model, adjust input gain, and set bridging mode.
Verify amp levels and prepare for the Auto Level Wizard process.
Complete Auto Level, prepare for Auto EQ, and set target curve.
Auto EQ finishes, and the AFS Wizard is initiated for feedback suppression.
Configure AFS filter settings and initiate the feedback search.
Advanced Feedback Suppression completes, and the preset is stored.
Name the new preset and save it to a user location.
To Next Page
