Need help?Do you have a question about the dbx DriveRack PA and is the answer not in the manual?
General| Input Channels | 2 |
|---|---|
| Output Channels | 6 |
| Frequency Response | 20Hz - 20kHz, +/- 0.5dB |
| Dynamic Range | >110 dB |
| A/D Converter | 24-bit |
| D/A Converter | 24-bit |
| Feedback Suppression | Yes |
| Output Impedance | 120 Ω balanced |
| Maximum Input Level | +22dBu |
| Maximum Output Level | +22dBu |
| Weight | 5.5 lbs |
| EQ | Graphic EQ, Parametric EQ |
| Crossover | Yes |
| Compressor | dbx Compressor |
| Limiter | dbx Limiting |
| RTA Mic Input | XLR |
| Delay | Yes |
| Metering | LED meters |
| Power Supply | 100-240V, 50-60Hz |
| Dimensions | 19" x 1.75" |
Adheres to critical safety guidelines including electrical safety, grounding procedures, and handling precautions.
Provides critical warnings for lithium batteries and specific safety advice for UK mains plugs.
Describes the rear panel connectors and their functions for system setup.
Details the components and controls found on the front panel of the DriveRack PA.
Details how to edit parameters for the Crossover and Advanced Feedback Suppression (AFS) modules.
Details the Pre-Crossover Graphic EQ and the Advanced Feedback Suppression (AFS) module, including their parameters.
Details the 2 or 3-band parametric EQ options available after the crossover section.
Describes the Compressor and Limiter modules, their parameters, and common applications.
Explains how to maximize system gain structure and use limiters to protect amplifiers from clipping.
To Next Page
