dbx DriveRack PA - Reset Procedures and Quick Key Options

®
®
®
®
®
®
Driv
eRack
®
P
A User Man
ual
36
Appendix A
DriveRack
®
PA
I
n the event that a reset is required, the DriveRack
®
P
A offers you the option of performing a “Soft” or “Hard” reset. The
Soft Reset resets all operating parameters except user programs. The Hard Reset Procedure will reset all programmable
information back to the factory defaults.
All Power-Up Functions require a button(s) to be pressed and held as the unit power is turned on.
DriveRack PA Power-Up Button Functions
Factory (“Hard”) Reset.
Press and hold the <STORE> button at power-up until the following message appears:
““!! HHAARRDD RREESSEETT??”
““YYeess <<PPRREEVV PPAAGGEE>>”
““NNoo <<PPRROOGGRRAAMM>>”
• Pressing the <PREV PAGE> button will start a Factory Reset (All User Programs will become
copies of the Factory Programs, all Utility settings will be defaulted, and all Security settings
will be defaulted).
• Pressing the <PROGRAM> button will abort the Factory Reset sequence and the unit will reset
normally.
System (“SOFT”) Reset
• Press and hold the <UTILITY> button at power-up until the following message appears:
““!! SSOOFFTT RREESSEETT??”
““YYeess <<PPRREEVV PPAAGGEE>>”
““NNoo <<PPRROOGGRRAAMM>>”
• Pressing the <PREV PAGE> button will start a System Reset (All Utility settings will be defaulted.)
• Pressing the <PROGRAM> button will abort the System Reset sequence and the unit will
reset normally.
The DriveRack
®
PA offer several “Quick Key” options for initial power up and are as follow:
Change Initial Program Number
• To change the initial power program number, Press and hold the <PROGRAM> button at
power-up until the following message appears:
UUssee WWhheeeell ttoo”CChhaannggee RReessttaarrtt”PPrrooggrraamm NNuummbbeerr”
• Turning the <DATA> wheel will select the program you wish to load at initial reset.
• Press the
<PROGRAM> button again when the selection is complete. Normal resetting will
continue.
System Lock Out
• Press and hold <WIZARD> at power-up until one of the following messages appears:
SSyysstteemm UUnnlloocckkeedd AAllll uusseerr iinnppuutt wwiillll bbee aacccceepptteedd
or
SSyysstteemm LLoocckkeedd NNoo uusseerr iinnppuutt wwiillll bbee aacccceepptteedd
• Rotating the <DATA> wheel to select either Lock, Unlock or Filter Unlocked the system.
• Pr
essing
<PREV P
A
GE>
will unlock the system if it wer
e locked or it will lock the system if it wer
e unlocked.
• If you wish to leave the system locked with the exception of being able to clear the feedback filters, follow the same
procedure on power up and then rotate the
<DATA> wheel to select the feedback filter unlock feature.
• Pressing any other button will abort the System Lockout sequence and the unit will reset normally.
A.2 Power Up Quick Key Options
A.1 Factory Reset