DCS RDV2 - Page 10

10
7 INSTALLATION SCENARIOS AND USE OF BACKGUARDS
Non-Combustible
Surface*
Non-combustible
surface*
(required)
ISLAND INSTALLATION
NO BACKGUARD USED
Integral Flat Vent Trim or
Angled Flat Vent Trim (
RGCV2-305 models only)
(supplied with range)
NO BACKGUARD USED
Integral Flat Vent Trim or Angled Flat Vent Trim (RGCV2-305 models only)
(supplied with range)
NO BACKGUARD USED
Integral Flat Vent Trim or Angled Flat Vent Trim (RGCV2-305 models only)
(supplied with range)
NO BACKGUARD USED
Integral Flat Vent Trim or
Angled Flat Vent Trim (
RGCV2-305 models only)
(supplied with range)
scenario 1
scenario 6 scenario 7
scenario 3 scenario 4
RANGE MOUNT LOW BACKGUARD
(purchased separately)
WALL MOUNT HIGH BACKGUARD LOW SHELF
(purchased separately)
scenario 5
WALL MOUNT HIGH BACKGUARD
HIGH SHELF AND ANGLED VENT TRIM KIT
(purchased separately)
Non-combustible
surface*
(required)
Non-combustible
surface*
or
Combustible
surface
scenario 2
Min. 6” (152mm)
Clearance
Combustible
Surface
Min. 6” (152mm)
Clearance
Combustible
Surface
WALL INSTALLATION
0” Clearance
cooking
surface
cooking
surface
cooking
surface
cooking
surface
0” Clearance
Range Mount
Low Backguard
10 3/8”
1/2”
(13mm)
(263mm)
Vent Trim
Vent Trim
cooking
surface
0” Clearance
Wall Mount
High Backguard
Low Shelf
1/2”
(13mm)
28 3/8”
(720mm)
Non-combustible
surface*
(required)
cooking
surface
0” Clearance
Wall Mount
High Backguard
High Shelf
Angled Vent Trim
(required)
1 5/16”
(33mm)
26 1/2”
(673mm)
cooking
surface