Dectron, Inc. March 2012
DSH/DSV/RSH/DBH/RBH Series Dehumidifier Owner’s Manual
Startup Warranty Registration
Data subject to change without notice.
244
Supply-Blower Voltage (V)
(when running)
Hot Gas O.D. (in.)
Liquid O.D. (in.)
Tube Length (ft.)
Measured Refrigerant-Tube Size(s)
Connecting Unit to Remote Condenser:
See safety warnings on a previous page. Close all access doors and panels. Be sure the O/A damper is in Occupied-Period position.
Start the supply blower. Note that other blowers may start also. After 3 minutes of blower operation, record the following:
See safety warnings on a previous page.
See safety warnings on a previous page. Adjust set points to cause all compressors to operate in dehumidification (only) mode. For
compressors with part-winding or Y-
ΔΔ
start, record the total phase currents. After 5 minutes of operation, record the following:
Optional outdoor air-cooled condenser
(s) (if any) location: Above D-O-T Below D-O-T Same level as D-O-T
Check here and skip to next section if there is no remote condenser.
Check here and skip to next section if condenser is factory-assembled to unit.
Check here and skip to next section if there is no DryCooler.
Circuit 1 Cir. 2
#1
Cir. 3 Cir. 4 Cir. 6 Cir. 7 Cir. 8
if any
Cir. 5
if any
L1 - L2 NameplateL2 - L3 (3
ΦΦ
only) L3 - L1 (3
ΦΦ
only)
Optional Condenser or DryCooler Voltage (V)
(when running)
L1 - L2
Nameplate
Voltage
L2 - L3 (3
ΦΦ
only) L3 - L1 (3
ΦΦ
only)
Supply-Blower
Current(s) (A)
(when running)
#2 #3 #4 #5 #6 #7 #8
L1
L2
L3
Nameplate Supply-
Blower Current (A)
(3
ΦΦ
only)
Compressor Voltage (V)
(when all running)
#1
if any
L1 - L2 NameplateL2 - L3 (3
ΦΦ
only) L3 - L1 (3
ΦΦ
only)
Compressor
Current(s) (A)
(when all running)
#2 #3 #4 #5 #6 #7 #8
L1
L2
L3
Nameplate
(3
ΦΦ
only)
Unit Ref.
Number
Page 2
of 4
STARTUP
To Next Page
Loading...
Need help?
General
