DECTRON
List of recommended equipment and tools:
NOTE: This list may not be comprehensive for any particular job. Use your judgement
.
Safety glasses
Lockout/tagout equipment, as appropriate
Dectron owners manual
Pen (for filling out forms)
Paper (for making notes)
Plastic trash bag, kraft paper, etc. (to cover controls while conduit is being installed)
Duct tape (to tape plastic over controls)
Knife (to cut duct tape, trim bushes and grass around remote condenser, if any)
Tape measure
Flashlight
Spirit level
Flat screwdrivers
Phillips screwdrivers
Needle-nose pliers
Open-end or combination wrenches, socket wrenches
Allen wrenches, including 1/4" and 5/16"
Metric Allen wrenches
Volt - Ohm meter
Clip-on ampmeter
Pack of 10kohm 1/4W resistors, (e.g. Radio Shack 271-1335)
Refrigerant gauges, manifold, hoses
Vacuum pump
Electronic micron-level vacuum gauge (Compound bourdon-tube gauges on manifolds are not even close to adequate.)
At least two schraeder-valve core-removal vacuum adapters
Refrigerant scale
Adequate refrigerant as specified on unit nameplate and in submittal
Remote-reading electronic thermometer with probe and minimum 6-foot cable
Brazing torch, fuel, etc., flux, filler rod, sandpaper, tube brush
Nitrogen (or other inert gas) tank, regulator, delivery hose
Tube cutter
Tube and fittings adequate to install air-cooled condenser, if any
Pipe and fittings adequate to install condensate drain
Pipe-joint compound
Bucket (to pour water into condensate pan)
Wire and cable as needed
Belt tension gauge
(optional, recommended) Refrigerant recovery machine and tanks
(optional, recommended) Alligator-clip jumper wires
(optional) Drill and bits, including masonry bits for wall anchors, if needed
(optional) Wall anchors and screws, as needed
(optional) Hoists, lifts, etc., as needed
(optional) Extension cords
(optional) Stepladder and other ladders, etc., as needed
(optional) Dectron submittal or other sales documents
(optional) Torque wrench, with sockets and other wrenches, as needed
(optional) Torque screwdriver (for electrical connections)
Dectron, Inc. March 2012
DSH/DSV/RSH/DBH/RBH Series Dehumidifier Owner’s Manual
Data subject to change without notice.
74
Installation Preparation
Note: Before proceeding, tape a paper or plastic sheet over all components in the
electrical enclosures. This is essential to protect the components from metal
chips produced during installation. Remove the sheet before applying power.
INSTALLATION
To Next Page
Loading...
Need help?
General
