DLED4 Series • Light Head and Power Supply • Instruction Manual • V1.1
20
7 Maintenance
Isolate electrically before re-lamping.
CAUTION - Hot LED module
Certainly, the LED module is not meant to be replaced by the user, and standard provides for its replacement to
be done by the manufacturer, his service representative or similar qualified person.
You may not bother placing the aforementioned labeling, if the operating instructions explicitly state that the LED
module is to be replaced only by the manufacturer or his service representative.
Always ensure good handling of the equipment and especially the cables. Cables are always a weak point and the
first to suffer if they are not handled properly.
In case of malfunction, please contact your dealer or an authorized service center.
To Next Page
