DEEP SEA ELECTRONICS DSEGenset DSE6120 MKIII - Controller Specifications and Requirements; Storage Temperature Specifications; Operating Temperature Specifications; UL Compliance Requirements

Specification
057-289 ISSUE: 1
Page 12 of 148
2 SPECIFICATION
2.1 STORAGE TEMPERATURE
Module
Specification
DSE61XX MKIII
-40 ºC +85 ºC (-40 ºF +185 ºF )
2.2 OPERATING TEMPERATURE
Module
Specification
DSE61XX MKIII
-30 ºC +70 ºC (-22 ºF +158 ºF )
2.3 REQUIREMENTS FOR UL
WARNING!: More than one live circuit exists, refer to section entitled Typical Wiring
Diagram elsewhere in this document
Description
Specification
Screw Terminal
Tightening Torque
4.5 lb-in (0.5 Nm)
Conductors
Terminals suitable for connection of conductor size AWG 20 to AWG 13
(0.5 mm² to 2.5 mm²).
Conductor protection must be provided in accordance with NFPA 70,
Article 240
Low voltage circuits (35 V or less) must be supplied from the engine
starting battery or an isolated secondary circuit.
The communication, sensor, and/or battery derived circuit conductors
shall be separated and secured to maintain at least ¼” (6 mm) separation
from the generator and mains connected circuit conductors unless all
conductors are rated 600 V or greater.
Current Inputs
Must be connected through UL Listed or Recognized isolating current
transformers with the secondary rating of 5 A max.
Communication Circuits
Must be connected to communication circuits of UL Listed equipment
Output Pilot Duty
0.5 A
Mounting
Suitable for use in type 1 Enclosure Type rating with surrounding air
temperature -22 ºF to +158 ºF (-30 ºC to +70 ºC)
Suitable for pollution degree 3 environments when voltage sensing inputs
do not exceed 300 V. When used to monitor voltages over
300 V device to be installed in an unventilated or filtered ventilation
enclosure to maintain a pollution degree 2 environment.
Operating Temperature
-22 ºF to +158 ºF (-30 ºC to +70 ºC)
Storage Temperature
-40 ºF to +176 ºF (-40 ºC to +80 ºC)