Need help?Do you have a question about the DEEP SEA ELECTRONICS DSEGenset DSE3110 and is the answer not in the manual?
General| Dimensions | 92 mm x 67 mm x 32 mm |
|---|---|
| DC Supply | 8 V to 35 V continuous |
| Magnetic Input Frequency | 10, 000 Hz (max) |
| Storage Temperature Range | -40°C to +85°C |
| Display Type | LCD |
| Input Voltage | 8 V to 35 V DC |
| Maximum Standby Current | 30mA |
| Protection Rating | IP65 (front only) |
| Relay Outputs | Start, Fuel, Auxiliary |
| Cranking Dropouts | Able to survive 0 V for 50 mS, providing supply was at least 10 V before dropout and supply recovers to 5 V. This is achieved without the need for internal batteries. |
Details voltage, current, and protection requirements for powering the DSE3110 module.
Explains how to connect the module to a PC via USB for configuration.
Details the CAN port connection for engine data communication using J1939 protocol.
Detailed descriptions of all module connection terminals and their purposes.
Explains the connection for PC configuration via the USB interface.
Provides a typical wiring diagram for basic installation and system setup.
Describes the function and operation of the module's front panel push-buttons.
Explains alarm icons indicating fault types (warning, trip, shutdown) and cycling behavior.
Lists shutdown icons for critical faults that immediately stop the generator.
Step-by-step instructions on how to start the engine using the manual/start button.
Instructions on how to stop the generator by selecting the Stop/Reset mode.
Details how to use the Stop/Reset mode to unload, stop, and reset the generator.
Explains how the generator operates automatically in Auto Mode, including starting and stopping.
Explains how to manually start and run the generator.
Guide on entering and navigating the module's front panel configuration editor.
Instructions on how to access the configuration editor using button combinations.
Details the process of selecting, adjusting, and saving parameters within the editor.
Lists and describes adjustable parameters available in the configuration editor.
Describes configuration for digital inputs, including source, polarity, action, and arming.
Details configuration options for digital outputs, including source and polarity.
Lists and explains various timers adjustable in the configuration editor.
Covers parameters related to alternator, voltage, and frequency settings for generator operation.
Details parameters for engine speed sensing, starting, and charge alternator.
Details selectable parameters and their available sources for configuration.
Lists available sources that can be assigned to digital outputs.
Lists available sources that can be assigned to digital inputs.
Troubleshooting guide for common starting issues and their possible remedies.
Troubleshooting guide for issues related to the generator not taking load or incorrect readings.
Lists common alarms, their symptoms, and possible solutions for troubleshooting.
To Next Page
