-10-
PREPARATION BEFORE FLIGHT
USB Adapter
(5V/1A)
Power Bank
① Connect the the drone's battery with the USB Charging Cable.
② Plug the USB Charging Cable into a USB charging port on the
power bank or USB adapter (5V/1A).
③ Charging time: about 70 minutes.
④ a. When the battery is charging, the indicator light on the USB
Charging Cable is Red.
b. When the battery is fully charged, the indicator light on the USB
Charging Cable will turn Green.
- Before charging, please read the instructions in the “Use of
Battery” section of the “Safety Guidelines” carefully!
- Please use the original charging cable to charge the battery.
- DO NOT charge the drone battery immediately after a flight as
the temperature of the battery may be too high. Please wait until it
cools down to room temperature before charging again.
* Low Battery Signal: The indicator lights on the drone will flash
continuously and the transmitter will beep during the flight.
CHARGING
To Next Page
Loading...
