Introduction
The PosiTector 6000 hand-held, electronic instrument
non-destructively measures the thickness of coatings on
metals, quickly and accurately. It consists of a body
(Standard or Advanced) and probe.
This Quick Guide summarizes the basic functions of the gage.
Download the full instruction manual at
www.defelsko.com/manuals
The PosiTector 6000 powers-up when the center navigation
button is pressed. To preserve battery life, the instrument
powers down after approximately 5 minutes of no activity. All
settings are retained.
1
1. Remove the protective rubber cap (if supplied) from probe.
2. Power-up Gage by pressing the center navigation button.
3. Place the probe FLAT on the surface to be measured.
HOLD STEADY. When a valid measurement is calculated,
the Gage BEEPS twice and the measurement is displayed.
4. Lift probe AT LEAST 2 INCHES (5 cm) from the surface
between measurements - OR - leave probe on the surface
in the same location for continuous measurements.
Quick Start
To navigate, use the Up and Down buttons to scroll vertically and
to SELECT.
Menu Operation
Gage functions are menu controlled. To access the Menu,
power-up the gage, then press the center navigation button.
Press the (
+
) button to switch
pages in a multipage menu.
Press the (
-
) button to return
to the previous menu or page.
Select Exit to exit from any menu.
Previous Page
(Exit)
Up
Next Page
Access the Menu
(Center/Select)
Down
To Next Page
Loading...
Need help?
General
