23
1. Remove the top plate from the tower speaker by pushing down on the right side
and then pulling up and removing the plate.
2. Align the DM90 speaker with the top of the tower speaker and place it irmly onto
the speaker making sure the connector on the bottom of the DM90 is seated into
the tower.
3. Connect additional speaker wires from the height channel speaker outputs of
your AVR to the Height Input binding posts on the tower.
Note: See the Quick Start Guide that came with your DM90 speakers for speciic
wiring instructions.
4. Make sure to properly adjust your AVR’s speaker coniguration to support the
number of height speakers you are adding.
Installing DM95 speakers
You can also mount DM95 speakers on your ceiling to create height channels for
Dolby Atmos. See page 15 for positioning information before you install the speakers.
To install DM95 speakers as height-channel speakers:
1. Mount the speaker on your wall. The ideal speaker placement is dependent on en-
vironment and personal preference. Review the included wall-mounting template
for mounting help.
2. Connect speaker wires to the DM95 speaker.
Note: See the Quick Start Guide that came with your DM95 speakers for speciic
wiring instructions.
3. Connect the other ends of your speaker wires to your receiver or ampliier. Be
sure to connect positive binding posts to positive binding posts, and negative to
negative.
4. Adjust the settings on your ampliier, then listen to Dolby Atmos or DTS:X content
to test the speaker sound and volume.
DM70DM80
1 2 3
To attach a DM90 height-channel speaker to your DM70 or DM80 tower speaker:
To Next Page
Loading...
Need help?
General
