Page 21
DANGER: Before replacing the
oven lamp, ensure that the
appliance is disconnected from
mains and cooled down to avoid
the risk of an electrical shock. Hot
surfaces may cause burns!
The oven lamp is a special
electric light bulb that can resist
up to 300°C. See Technical
specifications for details. Oven
lamps can be obtained from
Authorised Service Agents.
Position of lamp might vary from
the figure.
Replacing the oven light bulb
To replace a faulty light bulb, proceed as
follows:
1. Disconnect the product from mains.
2. Turn the glass cover counter clockwise
to remove it.
3. Remove the oven lamp by turning it
counter clockwise and replace it with
the new one.
4. Install the glass cover.
Oven light
The oven light is switched on by the
multifunction selector switch and switches
off when the knob is returned to 0.
Removing the oven door
SIDE OF DOOR
A
1
Oven door
(Only applies to models with removable oven
door).
The oven door may be removed to
improve access to the oven for cleaning
purposes.
1. Open the door fully to expose the hinges
(A) on either side.
2. Flip the hinge locking levers (B) to the
upright position.
3. Partially close the oven door and lift it free
of the side panel retaining slots.
4. After cleaning, re-fit the oven door in
reverse order making sure that the bottom
hinge notches © locate properly onto the
bottom edges of the side panel retaining
slots.
S
I
D
E
O
F
DO
O
R
C
3
SIDE OF DOOR
2
B
To Next Page
Loading...
