PAGE 5 OF 12
Electrical installation
This appliance must be earthed and the manufacturer and the seller do not
accept responsibility for any damage due to incorrect installation or
electrical connection.
Hobs with control panels
Earth leakage
This hob should not be connected through an earth leakage system.
Refer to S.A.N.S.10142
Connection to the power supply must be carried out by a licensed electrician, who
will ensure that the hob is correctly connected and safely earthed. The rated current is
printed on the serial number label attached to the base cover.
The hob must be connected to the mains through a double pole isolating switch which has
a minimum clearance between the contacts of 3 mm. in both poles.
A means for disconnection must be provided in the fixed wiring.
Note:
The appliance is not intended to be operated by means of an external timer or separate
remote-control system.
Hobs without control panels
Electrical connection is via connector blocks to the oven below the hob.
Please see the section pertaining to electrical connection as described in the oven
manual.
Safety advice
x This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
x Children should be supervised to ensure that they do not play with the appliance.
x Only use the appliance for preparing food.
x Do not leave hot fat or oil unattended. If overheating occurs, these could catch fire.
x Switch off the power at the mains in the event of a fault or when cleaning the appliance.
To Next Page
Loading...
Need help?
General