EasyManua.ls Logo

Dehler 32 - Antifouling Paint; Paint Remover; Holding Tank

Default Icon
67 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Yacht Manual DEHLER 32
58 - 67
9.6 Antifouling Paint
The part under the waterline of the Dehler 32 can be protected by antifouling paint, since
growth and vegetation means more energy consumption just to run the boat. The range of
protective paints is large, their effect is wide and therefore the type of paint can be suited to
every type of water.
If the anti-fouling paint needs to be sanded and repainted, discuss the work with your winter
storage firm. During the sanding work the surface under the boat must always be covered
with plastic or foil, in order to be able to dispose of the sanding dust as special rubbish.
9.7 Paint remover
Most paint removers are very aggressive and if possible should therefore not be used.
Mechanical removal of the paint layers, e.g. with a scraper should be preferred above all other
methods.
9.8 Holding tank
If your yacht is equipped with a sewage collection tank, it is essential to take care that in areas
where evacuation is forbidden, the seacock the connection for direct pumping outboard is
closed.
The capacity of the tank is limited. You should regularly check the level on the control panel
in the navigation area. As far as possible you should use the toilets in the pleasure harbours
or other places on land.

Table of Contents

Related product manuals