2.1.5 Factory settings
The Multi-line 2 unit is delivered from factory with certain factory settings. These are based on average values
and are not necessarily the correct settings for matching the engine/generator set in question. Precautions
must be taken to check the settings before running the engine/generator set.
2.2 About the guidelines
2.2.1 General purpose
This document includes general guidelines for commissioning of DEIF’s Multi-line 2 units. It mainly includes
instructions for settings, governor, AVR and protections check and unit adjustment. The general purpose of
the document is to supply general guidelines to be used in the commissioning of the Multi-line 2.
Please make sure to read this document before starting to work with the Multi-line 2 unit and
the genset to be controlled. Failure to do this could result in human injury or damage to the
equipment.
2.2.2 Intended users
These guidelines are mainly intended for the person responsible for the commissioning of the unit. In most
cases, this would be a commissioning engineer.
2.2.3 Contents and overall structure
This document is divided into chapters, and in order to make the structure simple and easy to use, each
chapter will begin from the top of a new page.
General guidelines for commissioning
4189340703 UK
General information
DEIF A/S Page 6 of 25
To Next Page
Loading...
Need help?
General
