Deif MIC-2 MKII - Page 7

7
Settings
Enter the setting mode in the mode selection screen.
Before accessing the parameter setting mode, a four digit password is required. The
default password is 0000. Insert the correct password and press .
4 options are available in the parameter selection
page:
• “SYS” for system parameter
• “I/O” for I/O module parameter
• “NET” for Ethernet module parameter
• “ALM” for alarm parameter.
Press or to move the cursor up or down.
Press to enter the selected parameter settings page.
Wiring, PT and CT settings
Enter “SYS” to change the following parameters:
• S04 for voltage wiring • S07 for secondary side PT ratio
• S05 for current wiring • S08 for primary side CT ratio
• S06 for primary side PT ratio • S09 for secondary side CT ratio.
For PT and CT ratio settings, press or to increase or decrease digit, press
to move the cursor to the next digit, press to accept your change. Exit from
“SYS” page, press .
H P E V/A
> Enter
>
>
H P E V/A
> Enter
>
>
H P E V/A
>
Enter
>
>
H P
E
V/A
> Enter
>
>
H
P
E V/A
> Enter
>
>
H P E V/A
>
Enter
>
>
H P E V/A
> Enter
>
>
H P E V/A
> Enter
>
>
H P E V/A
>
Enter
>
>