Deif XL User Manual (English)

To Next Page

Wiring of CAN version

Pin no. Function Note

Supply voltage

0 V

Consumption max. 150 mA

2 24 V

CAN connection

CAN 1 H input

CAN 1 line (sCAN line)

4 CAN 1 L input

5 CAN 1 GND

6 CAN 2 H input CAN 2 line/or for external

switch for calibrating sCAN

(See user’s manual)

7 CAN 2 L input

8 CAN 2 GND

Illumination

analogue dimmer

NC Dimmer input. Dimmer range 7

to 30 V

Consumption max. 30 mA

10 Illumination GND

11 Illumination +

After power-up, the LED will flash once or twice and is then turned off. If the LED keeps

flashing, there is no communication on the CANopen lines. Default setup of the Baud

rate is 125 kbit/s.



UICK GUIDE

Illuminated indicators, XL



Refer to www.deif.com for detailed information

Document no.: 4189350054A



The cable screen must never be connected to earth.

In case the communication is interrupted because of noise, connect the

cable screen to terminals 5 and 8 for dual CAN on all instruments in the

loop; do not connect the two screens.

The plate shown at the arrow is for fastening

the CAN cable by means of a strip.

The strip is not included.

Other manuals for Deif XL

Need help?

Do you have a question about the Deif XL and is the answer not in the manual?

General

Input	Voltage, Current, Frequency
Measurement Inputs	3-phase voltage, 3-phase current
Current Range	1A or 5A AC
Frequency Range	45 to 65 Hz
Communication	Modbus RTU
Display	LCD
Protection Class	IP20
Type	Multifunctional Meter
Output	Digital outputs, Analogue outputs (optional), Communication ports