DESIGNER’S HANDBOOK 4189350049C EN Page 101 of 206
NMEA is normally the default source setup for date and time:
This source setting is correct for the XDi-N where the NMEA time data is connected and selected in the initial
NMEA setup procedure.
Note: You can always go into NMEA input setup and see the actual NMEA data and time setup.
8.3.5.2 Local time offset shared via NMEA
If other XDi-N units needs the local offset via CAN bus, then “Send on CAN” and “Send interval” must be setup.
Now local time offset is shared via CAN 1 every 30 sec. It is also possible only to make it on a change instead, but
making transmissions periodical secures that all XDi units are synchronized regularly, even when they were
powered down at the latest change of the local offset.
To Next Page
Loading...
