Delem DA-40T Series - Table of Contents

V0220, 3
Table of contents
1. Introduction.................................................5
2. Using the DA-40T........................................6
2.1 User interface layout..................................................6
2.2 Available menus.........................................................7
2.3 Key lock .....................................................................8
2.4 On screen keyboard...................................................9
3. Program selection mode..........................11
3.1 Select a program from memory ...............................11
3.2 Copy/rename/delete a program from memory.........11
3.3 Create a new program .............................................13
3.4 Column sorting and changing column positions ......13
4. Automatic mode........................................15
4.1 Properties.................................................................15
4.2 All steps ...................................................................17
4.3 All steps parameters ................................................18
4.4 Program execution...................................................19
4.5 Manual positioning...................................................21
5. Manual mode.............................................22
5.1 Manual mode parameters........................................22
5.2 Program execution...................................................24
5.3 Manual positioning...................................................25
6. Settings mode ...........................................26
6.1 General....................................................................26
6.2 Tools........................................................................27
6.2.1 New tool......................................................28
6.2.2 Copy/rename/delete a tool from memory ...29
6.3 Materials ..................................................................30
6.4 Backup / restore.......................................................31
6.5 Program settings......................................................34