Delfield CoolScapes GBF1P-S

Questions and Answers

H
hendersontravisAug 16, 2025
Why is my Delfield CoolScapes GBF1P-S temperature too high?
- M
  Monique Moore MDAug 16, 2025
  If your Delfield Refrigerator's cabinet temperature is too high, there are several potential causes. Begin by ensuring the thermostat is set to a lower temperature. Check for and correct poor air circulation by rearranging the product inside. Recalibrate the exterior thermometer if it's out of calibration. Allow adequate time for warm products to cool down. Minimize prolonged door openings, ensure the doors are properly closed, and clean the condenser coil. Finally, if the evaporator coil is iced over, turn off the unit to defrost, and verify the thermostat isn't set too cold, also check the door gasket condition.
V
Vanessa TuckerAug 19, 2025
What does E13 mean on a Delfield Refrigerator display?
- P
  pphillipsAug 19, 2025
  If the temperature display on your Delfield Refrigerator reads E13, it indicates a communication error between the controller and the display. First, check for loose plugs on the cable connecting the control to the display. If the plugs are secure, the display or control may need to be replaced.
H
hamiltonmeganAug 21, 2025
What does E6 error mean on Delfield CoolScapes GBF1P-S Refrigerator?
- B
  Brenda JohnsonAug 21, 2025
  If the temperature display on your Delfield Refrigerator reads E6, it means the control has a defective potentiometer. Replace the control to resolve this issue.
M
Meghan ZavalaAug 25, 2025
What does E2 error mean on Delfield CoolScapes GBF1P-S?
- A
  Ashley PerezAug 25, 2025
  If the temperature display on your Delfield Refrigerator reads E2, the coil temperature sensor circuit is either open or shorted. Check the sensor's resistance for an open or short circuit. If either condition is found, replace the sensor. If the sensor is fine, the control may need to be replaced.
B
bradley58Aug 27, 2025
What does E1 mean on Delfield CoolScapes GBF1P-S Refrigerator display?
- D
  Danielle RobinsonAug 27, 2025
  If the temperature display on your Delfield Refrigerator reads E1, it indicates that the box temperature sensor circuit is either open or shorted. To solve this, check the resistance of the sensor for an open or short circuit. If either condition is found, replace the sensor. If the sensor checks out, the control might need replacing.
J
Jackie HarrisAug 30, 2025
Why is my Delfield CoolScapes GBF1P-S running constantly?
- A
  armstrongkristenAug 30, 2025
  If your Delfield Refrigerator's condensing unit runs for extended periods or continuously, it could be due to several reasons. First, check if you've placed an excessive amount of warm product inside; allow sufficient time for cooling. Ensure doors are closed when not in use to prevent prolonged openings. Inspect door gaskets for proper sealing, adjusting the door or replacing the gasket if needed. Clean the condenser coil, and if the evaporator coil is iced over, turn off the unit to defrost it, ensuring the thermostat isn't set too cold and that the gasket is in good condition.
T
Tanya WillisSep 2, 2025
How to fix a Delfield CoolScapes GBF1P-S Refrigerator that is not running?
- R
  Robyn HernandezSep 3, 2025
  If your Delfield Refrigerator cabinet isn't running, check the following: First, replace the fuse or reset the circuit breaker if it has blown or tripped. Ensure the power cord is plugged in. Adjust the thermostat to a lower temperature if it's set too high. Turn the main power switch on if it's off. If it's a freezer model, wait for the defrost cycle to complete.
M
michellerandallSep 5, 2025
What to do if Delfield CoolScapes GBF1P-S Refrigerator is freezing food?
- J
  Jerry CastanedaSep 5, 2025
  If your Delfield Refrigerator is freezing product, the thermostat might be set too low; try setting it to a higher temperature. A dirty condenser coil can also cause this issue, so cleaning it may help. Lastly, ensure there's enough cabinet clearance for proper refrigeration system operation; adjust the cabinet's position to improve clearance if needed.
C
Courtney WalkerSep 8, 2025
Why won't the compressor start on my Delfield CoolScapes GBF1P-S?
- D
  Daniel ShannonSep 8, 2025
  If your Delfield Refrigerator's compressor will not start, the issue might be due to low voltage. Check the incoming voltage to the cabinet and correct it as necessary.
J
Jennifer RodgersSep 12, 2025
How to fix a noisy Delfield Refrigerator?
- E
  Emily SmithSep 12, 2025
  If your Delfield Refrigerator is making unusual noises, locate and tighten any loose parts.