Figure 81. Removing the system battery
CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
2. To install a new system battery: To install a new system battery,
a) Hold the battery with the positive side facing up and slide it under the securing tabs.
b) Press the battery into the connector until it snaps into place.
Figure 82. Installing the system battery
Next steps
1. Install the LOM riser card.
2. If applicable, connect the cables to the expansion card(s).
3. Follow the procedure listed in the After working inside your system.
4. Confirm that the battery is operating properly, by performing the following steps:
a. Enter the System Setup, while booting, by pressing F2.
b. Enter the correct time and date in the System Setup Time and Date fields.
c. Exit the System Setup.
92
Installing and removing system components
To Next Page
Loading...
