Dell EMC PowerEdge R6515 - Memory Settings; Processor Settings

Option Description
AGESA Version Specifies the AGESA reference code version.
SMU Version Specifies the SMU firmware version.
DXIO Version Specifies the DXIO firmware version.
Memory Settings
To view the Memory Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS >
Memory Settings.
Table 14. Memory Settings details
Option Description
System Memory Size Specifies the memory size in the system.
System Memory Type Specifies the type of memory installed in the system.
System Memory Speed Specifies the system memory speed.
System Memory Voltage Specifies the system memory voltage.
Video Memory Specifies the amount of video memory.
System Memory Testing Specifies whether the system memory tests are run during system boot. The
two options available are Enabled and Disabled. This option is set to Disabled
by default.
Memory Operating Mode Specifies the memory operating mode. The option is available and is set to
Optimizer Mode, by default.
Current State of Memory Operating Mode Specifies the current state of the memory operating mode.
Opportunistic Self-Refresh Enables or disables opportunistic self-refresh feature. This option is set to
Disabled by default.
Processor Settings
To view the Processor Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS >
Processor Settings.
Table 15.
Processor Settings details
Option Description
Logical Processor Each processor core supports up to two logical processors. If this
option is set to Enabled, the BIOS displays all the logical
processors. If this option is set to Disabled, the BIOS displays only
one logical processor per core. This option is set to Enabled by
default.
Virtualization Technology Enables or disables the virtualization technology for the processor.
This option is set to Enabled by default.
IOMMU Support Enable or Disable IOMMU support. It is required to create IVRS
ACPI table. This option is set to Enabled by default.
L1 Stream HW Prefetcher Enables or disables the L1 stream hardware prefetcher. This option
is set to Enabled by default.
L2 Stream HW Prefetcher Enables or disables the L2 stream hardware prefetcher. This option
is set to Enabled by default.
MADT Core Enumeration Specifies the MADT Core Enumeration. This option is set to Linear
by default.
NUMA Nodes Per Socket Specifies the number of NUMA nodes per socket. This option is set
to 1 by default.
26 Pre-operating system management applications