Dell 100 Series - User Manual

100 Series 2U server
Dell EMC VxRack Node
Hardware Installation Guide
P/N 302-002-480
REV 07

Dell 100 Series Specifications

General

Processor	Intel Xeon E3-1200 series
Hard Drives	Up to 2 x 3.5" SATA HDD
Storage	SATA
Expansion Slots	1 x PCIe x16
Networking	Dual Gigabit Ethernet

Summary

Chapter 1: Before You Begin

Site Requirements

Outlines the essential environmental and facility prerequisites for installation.

Hardware Acclimation Times

Specifies the necessary time for hardware to acclimate to the operating environment.

Installing a 2 U1 N Configuration in a 40 U Cabinet

Details the procedure for physically installing a 2U1N server configuration in a 40U cabinet.

Installing a 2 U4 N Configuration in a 40 U Cabinet

Details the procedure for physically installing a 2U4N server configuration in a 40U cabinet.

Chapter 2: 2 U1 N Configuration Equipment Installation

2 U1 N Configuration Installation Guidelines

General guidelines for installing 2U1N components, including minimum and maximum configurations.

Install the 2 U1 N Server in the Cabinet

Step-by-step instructions for physically installing the 2U1N server into a rack.

Chapter 3: 2 U4 N Configuration Equipment Installation

2 U4 N Configuration Installation Guidelines

Install the 2 U4 N Server in the Cabinet

Step-by-step instructions for physically installing the 2U4N server into a rack.

Install the Management Server in the Cabinet

Procedure for installing the management server, including verifying mounting kit parts.

Install the Management Switch in the Cabinet

Steps to install the management switch into the server rack cabinet.

Configure the Management Switch

Install the Data Switch in the Cabinet

Configure the Data Switch

Chapter 7: Update the Install Database

Update the Install Database

Procedure for updating the system's installation database after all work is completed.