2. Install the slide rails in the cabinet with the hardware provided.
3. Position one of the inner rails on the mounting studs on corresponding side of
the replacement chassis.
4. Slide the inner rail forward until it clicks, which locks it in place on the server.
Figure 10 Attaching an inner rail to the server
5. Install the two screws to secure the inner rail to the server.
Figure 11 Install screws
6. Repeat these steps to install the inner rail to the other side of the server.
The server is heavy and should be installed in a rack by two people. To
avoid personal injury and/or damage to the equipment, do not attempt to
lift and install the enclosure
into a rack without a mechanical lift and/or help from another person.
7. On each slide rail, bring the ball bearing retainer assembly fully to the front of
the cabinet.
2U4N Configuration Equipment Installation
36 VxRack Node Hardware Installation Guide
To Next Page
Loading...
