Service Manual
Digital EDID Program Procedure
6.2.1 Connect the monitor and the ISP board via a DVI cable.
6.2.2 Connect the PC to the ISP board thru a parallel port cable.
6.2.3 Execute the programmer, “DELL 1x07 EDID – Digital”
The program will automatically force the resolution of the PC to be at 1024x768. By performing the
1x07FPf EDID, “DDC NO SUPPORT” will be shown first. Only “DDC NO SUPPORT” enables the EDID to
be flashed through the programmer. Please select “LPT” to continue the following reprogramming steps.
To Next Page
Loading...
