Dell 2335dn Multifunctional Laser Printer - Page 152

To enter the TCP/IP setting from your printer's operator panel, take the following steps:
Press Scroll ( or ) to highlight Setup and then press Select ( ).1.
Press Scroll ( or ) to highlight Network Setup and then press Select ( ).2.
Press Scroll ( or ) to select the network protocol you want to use and then press Select (
).
3.
If you selected TCP/IP (IPv4) .
Press Scroll ( or ) to select IPv4 Activate and then press Select ( ).a.
Press Scroll ( or ) to change the setting to On (enable) or Off (disable).b.
If you selected TCP/IP (IPv6) .
Press Scroll ( or ) to select IPv6 Activate and then press Select ( ).a.
Press Scroll ( or ) to change the setting to On (enable) or Off (disable).b.
Press Cancel ( ) to return to the Standby mode.d.
Static Addressing
To enter the TCP/IP address from your printer's operator panel, take the following steps:
Press Scroll ( or ) to highlight Setup and then press Select ( ).1.
Press Scroll ( or ) to highlight Network Setup and then press Select ( ).2.
Press Scroll ( or ) to highlight TCP/IP (IPv4) and then press Select ( ).3.
Press Scroll ( or ) to highlight Set IP Address and then press Select ( ).4.
The first available menu item, Manual , appears and then press Select ( ).5.
The first available menu item, Set IP Address displays.6.
Press Select ( ) to access the IP Address menu.7.
8.