Dell 2350D - Page 42

From this
menu:
You can:
Symbol Set Specify the symbol set for each font name.
Default: 10U PC-8
PCL Emulation Settings
Point
Size
NOTE: Only
for PostScript
emulation and
typographic
fonts.
Change the point size for scalable typographic fonts.
1.00 – 1008.00 in increments of 0.25
12.00*
Pitch
Assign the font pitch for scalable monospaced fonts.
Range: 0.08 – 100.00 in increments of 0.01
10.00*
Orientation
Specify the orientation of text and graphics on the page.
Portrait*
Landscape
Lines per
Page
Assign the number of lines that print on each page.
1–255
60*
A4 Width
Set the printer to print on A4-size paper.
198 mm*
203 mm
Auto CR
after LF
Specify whether the printer automatically performs a carriage return (CR)
after a line feed (LF) control command.
On
Off*
Auto LF
after CR
Specify whether the printer automatically performs a line feed (LF) after
a carriage return (CR) control command.
On
Off*
Tray Renumber
Assign
MP
Feeder
Assign
Configure the printer to work with printer software or programs that use
different source assignments for trays, drawers, and feeders.
200 = Off*
Symbol Set
Specify the symbol set for each font name.
Default: 10U PC-8
PCL Emulation Settings
Point
Size
NOTE: Only
for PostScript
emulation and
typographic
fonts.
Change the point size for scalable typographic fonts.
1.00 – 1008.00 in increments of 0.25
12.00*
Pitch
Assign the font pitch for scalable monospaced fonts.
Range: 0.08 – 100.00 in increments of 0.01
10.00*
Orientation
Specify the orientation of text and graphics on the page.
Portrait*
Landscape
Lines per
Page
Assign the number of lines that print on each page.
1–255
60*
A4 Width
Set the printer to print on A4-size paper.
198 mm*
203 mm
Auto CR
after LF
Specify whether the printer automatically performs a carriage return (CR)
after a line feed (LF) control command.
On
Off*
Auto LF
after CR
Specify whether the printer automatically performs a line feed (LF) after
a carriage return (CR) control command.
On
Off*
Tray Renumber
Assign
MP
Feeder
Assign
Configure the printer to work with printer software or programs that use
different source assignments for trays, drawers, and feeders.
200 = Off*
*Factory
default
setting