Dell 4100 - Remote Port Connector; Figure B-7. Pin Numbers for the Remote Port Connector; Table B-6. Pin Assignments for the Remote Port Connector

B-6 Dell PowerEdge 4100/180 and 4100/200 Systems User’s Guide
Remote Port Connector
The remote port connector may be used to monitor server
management functions by connecting an external Hayes-
compatible Smart Modem to the PowerEdge 4100
system. The modem configuration should be set to
9600baud, 8-bits, 1 stop bit, no parity, and no flow
control.
If you reconfigure your hardware, you may need pin
number and signal information for the remote port con-
nector. Figure B-7 illustrates the pin numbers for the
remote port connectors, and Table B-6 lists and defines
the pin assignments and interface signals for the remote
port connector.
Figure B-7. Pin Numbers for the Remote Port
Connector
1 — 5
6 — 9
Table B-6. Pin Assignments for the Remote Port
Connector
Pin Signal I/O Definition
1 DCD I Data carrier detect
2 SIN I Serial input
3 SOUT O Serial output
4 DTR O Data terminal ready
5 GND N/A Signal ground
6 DSR I Data set ready
7 RTS O Request to send
8 CTS I Clear to send
9 RI I Ring indicator
Shell N/A N/A Chassis ground