Dell 4100 - Table 3-1. Default SCSI Controller Settings

3-2 Dell PowerEdge 4100/180 and 4100/200 Systems User’s Guide
NOTES: The SCSISelect Utility must be run for both the
AIC-7880 and AIC-7860 SCSI controllers if you need to
change the configuration settings.
The term host adapter is used throughout this chapter to
refer to the built-in AIC-7880 and AIC-7860 SCSI con-
trollers or the optional AHA-2940 SCSI controller card.
For situations in which you might want or need to change
the settings, see the descriptions of each setting in the fol-
lowing subsections. To change any of the default settings
or to format or verify a disk, see “Starting the SCSISelect
Utility” found later in this chapter.
Table 3-1. Default SCSI Controller Settings
Setting Default
SCSI Bus Interface Definitions:
HOST ADAPTER SCSI ID 7
SCSI PARITY CHECKING ENABLED
HOST ADAPTER SCSI
TERMINATION
LOW ON/HIGH
ON
Boot Device Options:
BOOT TARGET ID 0
BOOT LUN NUMBER 0
SCSI Device/Configuration:
INITIATE SYNC NEGOTIATION YES (ENABLED)
MAXIMUM SYNC TRANSFER RATE 40 MB/SEC
ENABLE DISCONNECTION YES (ENABLED)
INITIATE WIDE NEGOTIATION YES (ENABLED)
SEND START UNIT COMMAND YES (ENABLED)
Advanced Host Adapter:
HOST ADAPTER BIOS ENABLED
SUPPORT REMOVABLE DISKS
UNDER BIOS AS FIXED DISKS
BOOT ONLY
EXTENDED BIOS TRANSLATION
FOR DOS DRIVERS > 1 GB
ENABLED
DISPLAY <CTRL><A> MESSAGE
DURING BIOS INITIALIZATION
ENABLED
MULTIPLE LUN SUPPORT DISABLED
BIOS SUPPORT FOR BOOTABLE
CD-ROM
ENABLED
BIOS SUPPORT FOR INT 13
EXTENSIONS
ENABLED
SUPPORT FOR ULTRA SCSI
SPEED
ENABLED
NOTE: For the full name of an abbreviation or acronym
used in this table, see the Glossary.