Dell 7330 User Manual

Overview of Network Setup and Configuration
Dell 7330 Mono Laser Printer
3-2
Overview of Network Setup and Configuration
To set up and configure the network:
1. Connect the printer to the network using the recommended hardware and cables.
2. Turn on the printer and the computer.
3. Print the Configuration page and keep it for referencing network settings.
4. Install the driver software on the computer from the Software and Documentation CD. For
information on driver installation, see the section in this chapter for the specific operating
system you are using.
5. Configure the printer’s TCP/IP address, which is required to identify the printer on the
network.
■ Windows operating systems: Run the Installer on the Software and Documentation
CD to automatically set the printer’s IP address if the printer is connected to an
established TCP/IP network. You can also manually set the printer’s IP address on the
control panel.
■ Macintosh systems: Manually set the printer’s TCP/IP address on the control panel.
6. Print a Configuration page to verify the new settings.
Note: If the Software and Documentation CD is not available, you can download the latest
driver from www.support.dell.com
.

Dell 7330 Specifications

General

Print Resolution	Up to 600 x 600 dpi
Copy Resolution	Up to 600 x 600 dpi
Scan Type	Flatbed, ADF
Fax Speed	33.6 Kbps
Duplex Printing	Yes
Operating System Compatibility	Windows, Mac OS, Linux
Functions	Print, Copy, Scan, Fax
Print Technology	Laser
Display	4.3" touchscreen
Connectivity	USB