Table 4. System setup options—Advanced menu
Advanced
Intel(R) SpeedStep(TM) Enables you to enable or disable Intel Speedstep
Technology.
Default: Enabled
NOTE: If enabled, the processor clock speed and core
voltage are adjusted dynamically based on the
processor load.
Integrated NIC Enables you to enable or disable the on-board LAN
controller.
Default: Enabled
USB Emulation Enables you to enable or disable the USB emulation feature.
This feature denes how the BIOS, in the absence of a USB-
aware operating system, handles USB devices. USB
emulation is always enabled during POST.
Default: Enabled
NOTE: You cannot boot any type of USB device
(oppy, hard drive, or memory key) when this option
is o.
USB Powershare Enables you to charge USB devices when the computer is
turned o or in standby mode.
Default: Enabled
USB Wake Support Enables you to enable the USB devices to wake the
computer from Standby.
Default: Disabled
NOTE: If USB PowerShare is enabled, a device
connected to the USB PowerShare connector may not
wake the computer.
Sleep Mode Enable or disable sleep mode.
Intel Speed Shift Technology Enable/disable Intel Speed Shift Technology support.
Setting this option to enable to allows the operating system
to select the appropriate processor performance
automatically.
Default: Enabled
SATA Operation Enables you to congure the operating mode of the
integrated SATA hard drive controller.
Default: AHCI
Adapter Warnings Ebales you to choose if the computer should display warning
messages when you use AC adapters that are not supported
by your computer.
Default: Enabled
Function Key Behavior Enables you to set function key or multimedia key as the
default function key behavior.
Default: Function key
Express Charge Enables you to charge your computer battery using
Standard Charge or Express Charge mode.
Default: Express Charge
Battery Health Displays the battery health.
Intel(R) Software Guard Extensions Enable or disable Intel Software Guard Extensions.
98
To Next Page
Loading...
