Figure 1. Remove BOSS-N1 Monolithic filler
2. Pull and lift the BOSS-N1 Monolithic controller carrier retention latch to open.
3. Slide the BOSS-N1 Monolithic controller carrier out.
Figure 2. Remove the BOSS-N1 Monolithiccontroller carrier
4. Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 NVMe SSD carrier to the
BOSS-N1 Monolithic controller.
5. Slide the M.2 SSD out and up from the BOSS-N1 Monolithic controller.
18
Install and remove a BOSS-N1 controllers
To Next Page
Loading...
