Dell BOSS-N1 - Page 21

Figure 6. Install the BOSS-N1 Monolithic controller filler
2. Connect the BOSS power cable and BOSS signal cable to the BOSS-N1 Monolithic controller module.
Figure 7. Connect the BOSS power cable and BOSS signal cable to the BOSS-N1 Monolithic controller module
3. Align the BOSS-N1 Monolithic controller module at an angle with the controller module slot.
4. Insert the BOSS-N1 Monolithic controller module and push the controller module towards the back of the chassis until it is
secured.
5. Using the Phillips #1 screwdriver secure the BOSS-N1 Monolithic controller module with the M3 x 0.5 x 4.5 mm screw.
6. Connect the BOSS power cable and the BOSS signal cable to the connectors on the system board.
Install and remove a BOSS-N1 controllers
21