4. Install the cover
5. Follow the procedure in After Working Inside Your Computer.
Hard drive
Removing the 3.5-inch hard drive chassis assembly
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. cover
b. front bezel
c. cooling shroud
3. Disconnect the power and the data cables from the hard drive [1].
NOTE: For easy access to the power and the data cables, it is recommended to remove the cooling shroud.
4. Remove the 6-32xL3.6two 6-32xL6.35 screws that secure the 3.5-inch hard drive chassis to the drive bay [2].
22
Disassembly and reassembly
To Next Page
Loading...
