Option Description
● WLAN Only
● LAN or WLAN
● LAN with PXE Boot
Block Sleep This option lets you block entering to sleep (S3 state) in operating system environment.
Block Sleep (S3 state)
Default setting: This option is disabled
Intel Ready Mode Allows you to replace sleep S3 to put your PC in an always aware state that allows the user to interact
with it even while the PC is asleep
● Eanble Intel Ready Mode: The option is disabled.
POST Behavior screen options
Option
Description
Numlock LED This option option specifies whether the NumLock LED should be on when the system boots.
● Enable Numlock LED: The option is enabled.
Keyboard Errors This option option specifies whether the keyboard related errors are reported when it boots.
● Enables Keyboard Error Detection: The option is disabled.
Fastboot Allows you to speed up the boot process by bypassing some of the compatibility steps. The options are:
● Minimal(default)
● Thorough
● Auto
Virtualization support screen options
Option
Description
Virtualization Allows you to enable or disable the Intel Virtualization Technology.
Enable Intel Virtualization Technology (default).
VT for Direct I/O Enables or disables the Virtual Machine Monitor (VMM) from utilizing the additional hardware capabilities
provided by Intel® Virtualization technology for direct I/O.
Enable VT for Direct I/O - enabled by default.
Maintenance screen options
Option
Description
Service Tag Displays the Service Tag of your computer.
Asset Tag Allows you to create a system asset tag if an asset tag is not already set. This option is not set by default.
SERR Messages This field controls the SERR message mechanism. Some graphic card required the SERR message.
● Enable SERR Messages (default)
BIOS Downgrade This field controls flashing of the system firmware to pervious revisions.
Allows BIOS Downgrade (Enabled by default)
Data Wipe This field enables user to erase data from all internal storage device.
BIOS Recovery Allows you to recover from certain corrupted BIOS conditions from a recover file on the user primary hard
drive or an external USB key. Enabled by default.
System Setup overview 85
To Next Page
Loading...
