5. Follow the steps to remove the system board:
a. Remove the 6-32xL6.35 screws that secure system board to the chassis [1].
b. Lift the system board from the chassis.
Installing the system board
1. Insert the system board and ensure that ports are aligned to the holes on the back panel.
2. Tighten the 6-32xL6.35 screws to secure the system board.
3. Push the I/O panel to its original position until it snaps in.
4. Tighten the 6-32xL6.35 screw to secure the I/O panel to the chassis.
Disassembly and reassembly
55
To Next Page
Loading...
