d. 3.5-inch hard drive chassis
e. drive cage
3. Follow the steps to remove the bracket from the optical drive.
a. Remove the M2L2(04)three M2x2 screws that secure the bracket to the optical drive [1].
b. Slide the optical drive from the bracket [2].
NOTE: Remove the optical-drive bracket only if you are replacing with a new optical drive. Otherwise, if optical drive
removal is only a pre-requisite to remove other components, then ignore Step 5 and Step 6
Installing the optical drive
1. Slide the optical drive into the drive bay until it snaps [1].
2. Tighten the M2L2(04)three M2x2 screws to secure the optical drive to the bracket [2].
30
Disassembly and reassembly
To Next Page
Loading...
