34 Solving Problems
www.dell.com | support.dell.com
No sound from headphones
Video and Monitor Problems
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
NOTE: See the monitor documentation for troubleshooting procedures.
If the screen is blank
RUN THE SPEAKER DIAGNOSTICS
REINSTALL THE SOUND DRIVER — See page 43.
RUN THE HARDWARE TROUBLESHOOTER — See page 46.
CHECK THE HEADPHONE CABLE CONNECTION — Ensure that the headphone cable is securely inserted
into the headphone connector (see page 49).
ADJUST THE WINDOWS VOLUME CONTROL — Click or double-click the speaker icon in the lower-right
corner of your screen. Ensure that the volume is turned up and that the sound is not muted.
CONNECT THE MONITOR TO THE CORRECT VIDEO CONNECTOR — If the integrated video connector on
your computer is covered by a cap, do not remove the cap to connect the monitor, or the monitor will
not function. Connect your monitor to the video connector on the graphics card..
CHECK THE MONITOR CABLE CONNECTION —
• Ensure that the graphics cable is connected as shown on the setup diagram for your computer.
• If you are using a graphics extension cable and removing the cable solves the problem, the cable is
defective.
• Swap the computer and monitor power cables to determine if the power cable is defective.
• Check the connector for bent or broken pins. (It is normal for monitor cable connectors to have missing
pins.)
CHECK THE MONITOR POWER LIGHT — If the power light is off, firmly press the button to ensure that
the monitor is turned on. If the power light is lit or blinking, the monitor has power. If the power light is
blinking, press a key on the keyboard or move the mouse.
To Next Page
Loading...
