Removing and Installing Parts 81
Floppy Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet
before opening the cover.
1
Follow the procedures in "Before You Begin" on page 47.
2
Release and remove the front panel (see page 70).
NOTE: If you are adding a floppy drive, see "Installing a Floppy Drive" on page 82.
Removing a Floppy Drive
1
Disconnect the power and data cables from the back of the floppy drive and from the system
board (see page 56).
2
Remove the floppy drive bracket from the computer:
a
Remove the bracket-securing screw for the floppy drive.
b
Remove the bracket for the floppy drive from the computer.
power cable
data cable
To Next Page
Loading...
