1. Working from the rear of the monitor, attach the Soundbar aligning the two slots with the two tabs along the bottom rear of the monitor.
2. Slide the Soundbar to the left until it snaps into place.
3. Connect the soundbar with the power brick.
4. Plug the power cables of the power brick into a nearby outlet.
5. Insert the lime-green mini stereo plug from the rear of the Soundbar into the computer's audio output jack.
NOTICE: The graphic is for illustration only. Product appearance may vary.
NOTE: The base removal is not necessary to install the soundbar. Shown with base detached for illustration purposes only.
Back to Contents Page
To Next Page
Loading...
